Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Spring Hill, TN

Extension Spring Replacement in Spring Hill, TN

Side-mounted extension springs replaced in matched pairs, with safety cables installed. Typical cost $150-$350.

Our extension spring replacement service in Spring Hill, TN comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for extension spring replacement?

  • A stretched, sagging or snapped spring along one of the horizontal tracks
  • The door lifts unevenly or sits crooked
  • A missing or broken safety cable through the spring
  • Pulleys squealing or wobbling

Common causes

  • Metal fatigue from years of stretching
  • Rust and worn pulleys
  • Mismatched springs from an earlier repair

Before the technician arrives

  • Make sure each extension spring has a safety cable running through it. That cable keeps a snapped spring from flying across the garage.
  • Look at the pulleys and cables for fraying.
  • Don't try to stretch or re-hook an extension spring under tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Open the door fully and secure it so spring tension is released
  2. Replace both springs as a matched pair, color-coded for door weight
  3. Replace worn pulleys and lift cables if needed
  4. Install or replace the safety containment cables
  5. Balance the door and test it through several cycles

How much does extension spring replacement cost?

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Extension Spring Replacement in Spring Hill, TN

Humidity in Tennessee puts a thin layer of rust on spring coils, and that friction wears springs out early. Coated or galvanized springs last noticeably longer here.

Besides Spring Hill (ZIP code 37174), we handle extension spring replacement in Thompson's Station (3.7 mi), Columbia (11.1 mi), Franklin (12.5 mi) and Fairview (19.2 mi). Call (833) 435-8883 to book a visit in Spring Hill.

Extension Spring Replacement: frequently asked questions

How much does extension spring replacement cost in Spring Hill, TN?

Extension Spring Replacement typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do extension spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is extension spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Tennessee or Spring Hill requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Spring Hill, TN

Ideal Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Chamberlain Remote & Keypad Programming

Chamberlain is the retail line of The Chamberlain Group, sold at home centers. It uses the same Security+ 2.0 remote technology and myQ app as LiftMaster, so many accessories work with both brands.

Typical $50-$150

Raynor Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Northwest Door Garage Door Installation

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Typical $1,200-$4,500

Midland Garage Door Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Ryobi Smart Garage Door Opener Setup

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $100-$900

Linear Garage Door Opener Installation

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $350-$800

Craftsman Garage Door Opener Installation

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $350-$800

Ryobi Remote & Keypad Programming

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $50-$150

Wayne Dalton Off-Track Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $175-$450

CHI Overhead Doors Garage Door Panel Replacement

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $300-$900

Garage door stuck, noisy or broken?

Talk to a garage door technician in Spring Hill, TN now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote